Power ECU CFMoto CForce 800/850 Gen2 (2018-2024)
567,60 € 567,60 €
incl. 20% VAT plus shipping costs
Vauhti Varikko Power ECU CFMoto CForce 800/850 GEN2
Plus 7 HP more to wheels!
- More Torque
- Better AFR
- New Timing maps
- New fine tuned Throttle Maps
- Fine tuned Drive modes
- Adjusted Torque Limiters
- Softer Downhill Assistant
- Higher speed at L gear
- Higher speed at R gear
- Max top speed
- Plug and Play Performance
POWER ECU is only for OFF-ROAD and/or RACING USE!
Availability : in stock
In stock (can be backordered)
Vauhti Varikko Power ECU CFMoto CForce 800/850 GEN2
Easy to use replacement ECU (Engine Control Unit). Simply remove the standard ECU and connect the Power ECU!
(Please refer to the manufacturer's installation instructions)
All ECU software’s are developed by professional tuners using engine and wheel dynos and tested by industry’s biggest test group: Team Vauhti Varikko professional drivers..
POWER ECU is only for OFF-ROAD and/or RACING USE!
WORKS WITH THE FOLLOWING MODELS
CFMoto CFORCE 800 Gen2, 2018-2024
CFMoto CFORCE 850 Gen2, 2018-2024
INSTRUCTION
Vauhti Varikko Power ECU CFMoto CForce 800/850 Gen2 – Instruction from manufacturer
- Make sure the vehicle ignition is turned OFF!
- Disconnect battery negative terminal.
- Locate the ECU and remove necessary screws to access the ECU.
- Carefully disconnect the old ECU. Be careful not to damage contacts between ECU and connector.
- Carefully connect new Power ECU. Be careful not to damage contacts between ECU and connector.
- Reconnect the battery negative terminal.
- Switch on the ignition and wait 60 seconds for the new Power ECU to communicate with the vehicle.
- Start the engine and let it idle for 5 minutes to adapt to new values.
- In some rare cases, fault code or engine light can occur. Usually, it is cleared after couple of engine starts and stops OR the fault code can be cleared with OBD diagnostic cable.
Have fun with your new Power ECU!
Vauhti Varikko
www.vauhtivarikko.com
Reviews
There are no reviews yet.