Speed Limiter Removed ECU CFMoto UForce 1000 XL (2023+)
319,68 € 319,68 €
incl. 20% VAT plus shipping costs
Speed Limiter Removed ECU CFMoto UForce 1000 XL (2023+)
- replacement Bosch ME17 ECU
- removed speed limiter
- FOR OFF-ROAD / RACING USE only!
- Plug and Play
This ECU is only for OFF-ROAD and/or RACING USE!
Availability : in stock
In stock (can be backordered)
Speed Limiter Removed ECU CFMoto UForce 1000 XL (2023+)
Easy to use replacement ECU (Engine Control Unit). Simply remove the standard ECU and connect the new ECU!
(Please refer to the manufacturer's installation instructions)
The Bosch ME17 replacement ECU without speed limiter is for OFFROAD and/or RACE USE only!
WORKS WITH THE FOLLOWING MODELS
CFMoto CForce 1000 Gen3, 2024-current
INSTRUCTION
IB ECU CFMoto – speed limiter removed – Instruction from manufacturer
- Make sure the vehicle ignition is turned OFF!
- Disconnect battery negative terminal.
- Locate the ECU and remove necessary screws to access the ECU.
- Carefully disconnect the old ECU. Be careful not to damage contacts between ECU and connector.
- Carefully connect new ECU. Be careful not to damage contacts between ECU and connector.
- Reconnect the battery negative terminal.
- Switch on the ignition and wait 60 seconds for the new ECU to communicate with the vehicle.
- Start the engine and let it idle for 5 minutes to adapt to new values.
- In some rare cases, fault code or engine light can occur. Usually, it is cleared after couple of engine starts and stops OR the fault code can be cleared with OBD diagnostic cable.
Add a review
Produktanfrage / Request to product: Speed Limiter Removed ECU CFMoto UForce 1000 XL (2023+)
You may also like
Related Products
Reviews
There are no reviews yet.